What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?
Last Updated: 21.06.2025 11:37
One is “what exactly is in a ‘surge protector’ ? ”
In schematic diagrams this is the symbol for a fuse:
Lightning arrestor is a spark-gap device, and can be installed anywhere. What is important, is that the wire is thick enough to withstand the lightning bolt and conduct the energy away from the building.
“ … to protect building, lightning arrestor, is provided above building and directly connected to earth.”
It also is a device that limits the change in current flow.
a photo is worth a thousand words.
Travis Kelce Salutes Taylor Swift for Buying Her Masters Back, 'It's Finally Hers' - Bleacher Report
nine
This is where the MOV conducts again, and dissipated the energy.
An AC voltage/ current source, and an ac inductive load.
What happens to single guys when they get older?
Fuses, on their own, then operate much slower than the MOV variable resistance, during the lightning strike.
(There is no concept of polarity, in the loop because the current changes direction 100 to 120 times a second (power frequency).
The bolt then partially travels down the line to your home.
A fuse is a non-resetable over current circuit protector.
2024–10–10[John johnson John Johnson ]
This device then solves the entire problem.
Veritatis voluptatem autem enim similique quo quasi magnam tempora.
So combined with a device called a MOV or Metal-oxide-resistor, then forms the 3rd part of a “surge suppressor “.
Barnstars:
There are three different concepts here that are getting confused.
This Week In Space podcast: Episode 165 — Guardians of Space - Space
P = e* I, so since I is 16 amps, then the voltage dropped is 1/16 volt or 0.0650 volts.
These devices are installed between the “hot” and “neutral” and protective ground.
The other is “what does a “fuse” do?”
When was the first time you suck on a penis?
but I think this circuit , shows a few more pieces.
2024–10–11 [Bobby Sanchez Bobby Sanchez ].
Upvotes:
I convinced HP's board to buy Palm and watched them kill it - Hacker News
Here is a simplified AC power diagram.
2024–10–16 [ OO OLAOYE OYEBODE ]
The third is lightning and “how it gets conducted into a home.”
What was something you did naughty with your cousin?
This one hit behind the barn.
This is a high voltage low current spike that comes down the line because of the power poles being struck, and the voltage suppressors activating on the primary side of the transformer.
He then describes the function of a fuse.
There are two important concepts here.
Is the question then , "why buy a surge supressor, if the fuse alone protects the electronic circuits from a lightning bolt?".
For this case there are devices called Metal oxide varistors (MOV).
2024–09–27 [ Mohan Rajaratnam Mohan Rajaratnam ] . Thinks you can get free electricity from nothing : Mohan Rajaratnam's answer to Is it possible to generate free electricity at home using a magnet or other low-cost methods? If so, how does it work?
2024–10–11 [Victor Olarewsju Victor Olarewaju ]
Mohan forgets that a fuse is a one-time device, and needs to be replaced if it is tripped.
So, the voltage could go up to 500 volts, and the fuse will not open up.
2024–10–14 [Omar Gharbi Omar Gharbi ]
A circuit breaker is similar, but is resettable.
Once the voltage goes over 0.0650 volts, then this fact can be used to amplify the difference, and turn the circuit breaker off , furthur down the line. Essentially that is what a RCD/GFCI does, it compares the incoming current, to the outgoing current, and if the difference between the two currents is over 5mA, then it trips the circuit breaker.
the problem then depends on "how fast does the fuse operate?".
so, what happens?
One
This is a photo where a lightning bolt took out a home's complete mains distribution box, and a lot of electronic gear as well.
This is an electronic circuit designed to clamp voltages so that the Voltage Potential that appears at the outlet is never going to exceed the nominal value.
At one ohm, the resistor has a maximum of 1 watt power.
He then asserts :
At the secondary, it is 1000 times less.)turns ratio). If it gets hit with a 100,000 volt bolt of lightning then the voltage arrestors conduct and clamp the voltage down to line voltage, ( but a small amount leaks down the line). This is the problem.
But it can get overloaded, and no longer works.
This is where this question deviates from being a 'generic' question, and becomes more specific.
so, the loop of wire then, when put together with another loop reduces the ‘noise’ on a power line.
Edit 2024–10.
what exactly is a ‘surge’ protector?
“ A surge suppressor is the one which is connected at the input supply so that when there is a sudden change voltage it bypasses thereby protecting the (circuit) and electronic components”
(Dc diagram shown, AC is similar).
When the current is 200% of the rated value , it will “go open” (the link metal melts) and protect the device.
These are simplified answers to the original question, and does not change anything I wrote above.
Would individual surge supressors have save this equipment? most likely, since the surge supressor would take the jolt instead of the electronic components.
Now when you have a certain ac resistance, then a current flows in a loop.
2024–10–00 [ Ammar Mahdi ] Ammar Mahdi
This is 'the assistant's answer'
If the nominal power is 4,000 watts then the current at 230volts is 16 amps.
At least they know the answer if they wanted it.
OK, this is Mohan Rajaratnam’s definition of a Surge suppressor.
but this device (an Inductor) … impedes the rapid changes in the current.
And this is the problem alone. Is the power supply in the equipmemt designed with a lightning strike in mind? Some yes, others, no.
What is lightning?
The MOV will conduct when the voltage exceeds 50% of line voltage.
So, it’s possible that these devices from Trip Lite have addition suppression devices, these ones seem to be sturdy.
There is no harm in having the surge suppressor along with the fuse in the circuit. The fuse will not open up until the current melts the link. This will take time, and in the interim, that jolt will get transmitted into the power supplies.
It seems Mohan does not understand the difference between a comment and an Answer.
What does a fuse do?
But… the neutral is now “floating” because of the 1 ohm resistance.
“ A fuse is a device which protects the (circuit) against overload and short circuit.”
eight
[old diagram got deleted by accident]
This is the picture of an electronic coil of wire wound around a core of magnetic material.
First Sentence:
I post the exact comment here.
But during the surge, the fuse will not blow if it is a longer duration and lower value )10 to 50%).
He then describes Rainy Season and Lightning.
Can the fuse protect the electronic devices from lightning instead of a surge protector.
Because the load is inductive, the current lags the voltage.(by a bit).
It’s been three xxx five werks, and there has been no response to my follow on query on his Commment to my answer.
[image of Common-mode choke]